Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
+ Brake system
- Suspension bracket and steering
The general information
- Forward suspension bracket
Removal, dismantling, assemblage and installation of a nave and rotary fist
Removal, dismantling assemblage and installation of a rack of a suspension bracket
Removal and installation of the bottom lever of a suspension bracket
Check and replacement of a spherical support of a suspension bracket
Removal, installation and check of the stabilizer of a suspension bracket
+ Back suspension bracket
+ Steering
+ Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections
|
Forward suspension bracket
Removal, dismantling, assemblage and installation of a nave and rotary fist
Removal and installation
Components of installation and assemblage of a nave and rotary fist
|
|
- Remove a forward wheel.
- Measure axial люфт the bearing of a nave of a forward wheel and axial palpation of a nave. For this purpose preliminary remove a brake support and a brake disk (the Brake system see the Head).
|
|
Reliably tie up a support so that it was not bent and the flexible brake hose was not loaded. Compare results of measurements to requirements of Specifications of the Head the Suspension bracket and a steering and if necessary replace the nave bearing. Establish to the place of a brake disk and a support. |
- Take pin counternuts of a power shaft and, having squeezed out a brake pedal, turn out a counternut.
- Remove a brake support and a brake disk (the Brake system see the Head).
|
|
Reliably tie up a support so that it was not bent and the flexible brake hose was not loaded. |
- Turn out fixture of the gauge of speed ABS and the holder of its electroconducting.
- Loosen the, two nuts of fastening of a rack of a suspension bracket to a rotary fist.
|
|
- Take pin nuts of a tip of steering draught, turn out a nut and by means of the special adaptation disconnect a tip of steering draught from a rotary fist.
|
- Turn out a bolt and two nuts and disconnect a spherical support from the bottom lever of a forward suspension bracket.
- Completely turn out two bolts of fastening of a rack of a suspension bracket to a rotary fist and remove assemblage of a rotary fist with a nave.
|
|
Do not damage a protective casing and a rotor of the gauge of speed ABS. |
- Installation is made upside-down. After installation check up a signal from gauge ABS.
|
|
Dismantling and assemblage
|
|
- Take a screw-driver duster.
|
|
- Take pin nuts of fastening of a spherical support, turn out a nut and by means of the special adaptation remove a spherical support from a rotary fist.
|
|
|
- Remove a nave by means of the special adaptation.
|
- Выпрессуйте an internal holder (outside of) the nave bearing.
- Turn out 4 bolts and remove a protective casing of a rotary fist.
- Take a lock ring and выпрессуйте the bearing of a nave from a rotary fist.
|
|
- If necessary remove bolts of a nave by means of the special adaptation. Installation of bolts is made by a nut tightening.
|
|
|
- Assemblage is made upside-down. Tighten connections with demanded efforts. At installation duster level an aperture in it (for gauge ABS) with an aperture on a rotary fist. Use new ступичный the bearing and new pin nuts of fastening of a spherical support.
|
|
|
|
|