Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
- Brake system
The general information and security measures
Removal, installation and check of pedals of brake system
Check of brake system through a socket of the module of management
Removal and installation of the tank and the main brake cylinder (ГТЦ)
Removal, check and installation of the amplifier of brakes
Replacement brake pads
Removal, dismantling, check, assemblage and installation of supports of brake mechanisms
Dismantling, check and assemblage of a lay brake
Check of the valve of distribution of brake effort
Removal and installation of the activator of brakes
Removal and installation of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections
|
Removal and installation of the activator of brakes
Components of installation and activator assemblage
|
|
- Remove the right forward wheel and локер its arches.
- Turn out a bolt of fastening of the holder of tube ГУР.
- Shift forward broad tank ОЖ and remove it to the holder.
- Separate 4 socket and disconnect hoses from the activator of brakes.
- Disconnect from assemblage of the activator of brakes of 6 brake tubes.
- Turn out two bolts and a nut and remove activator assemblage.
- Turn out two nuts and remove the activator from an arm.
- Remove from the activator two holders and three linings.
- Installation is made upside-down.
- After installation fill tank GTTS with a brake liquid and pump over brake system (the Section Replacement of a brake liquid, prorolling of brake system see).
|
|
|
|