LEXUS RX 300

1998-2003 of release

Repair and car operation


Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
- Brake system
   The general information and security measures
   Removal, installation and check of pedals of brake system
   Check of brake system through a socket of the module of management
   Removal and installation of the tank and the main brake cylinder (ГТЦ)
   Removal, check and installation of the amplifier of brakes
   Replacement brake pads
   Removal, dismantling, check, assemblage and installation of supports of brake mechanisms
   Dismantling, check and assemblage of a lay brake
   Check of the valve of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections



Replacement brake pads

The description of check brake pads is resulted in Section the General checks of brake system.

Assemblage of the forward brake mechanism

1 — the prorolling Union
2 — the Support
3 — the Lining
4 — the Directing pin
5 — the Piston
6 — piston Consolidation
7 — a piston Cover
8 — the Ring of a cover of the piston
9 — the Directing plug

10 — Pylnik
11 — the Brake disk
12 — Skoba of a support
13 — Holders brake pads
14 — the Display plate of deterioration pads
15 — Antivizgovaja an overlay
16 — Internal антивизговая an overlay
17 — Internal brake колодка
18 — External brake колодка


 PERFORMANCE ORDER

  1. Assemblage of the brake mechanism of a back wheel is resulted on an illustration Assemblage of the back brake mechanism.
  2. Remove a corresponding wheel and temporarily fix a brake disk wheel nuts.
  3. Turn out a bolt of fastening of a support, cast away a support and reliably tie up it.

Do not disconnect flexible hoses from a support.

  1. Remove 2 brake pads with four антивизговыми overlays and a display plate of deterioration pads.
  2. Remove 2 holders brake pads.

Not deformed holders it is possible to use repeatedly.

  1. Check up a condition of a brake disk (the Section the General checks of brake system see).
  2. Installation is made in an order, the return to an order of dismantle of components. Turn снимание on following remarks:
    • At installation new pads establish as well new антивизговые overlays;
    • Both parties internal антивизговых overlays grease with special greasing for brakes;
    • Do not suppose hit of oil and greasing on frictional overlays brake pads;
    • At support installation wring out the piston, for example, the hammer handle if the piston goes hardly, loosen the the prorolling union to allow to flow out a brake liquid;
    • Tighten all connections with demanded efforts.