LEXUS RX 300

1998-2003 of release

Repair and car operation



Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
+ Brake system
- Suspension bracket and steering
   The general information
   - Forward suspension bracket
      Removal, dismantling, assemblage and installation of a nave and rotary fist
      Removal, dismantling assemblage and installation of a rack of a suspension bracket
      Removal and installation of the bottom lever of a suspension bracket
      Check and replacement of a spherical support of a suspension bracket
      Removal, installation and check of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections




Removal, dismantling assemblage and installation of a rack of a suspension bracket

Removal, dismantling and check

Components of a rack of a forward suspension bracket

1 — Remove the tank of a brake liquid
2 — rack Assemblage
3 — a stabilizer Rack
4 — the Top support of a rack
5 — the Bearing
6 — the Top saddle of a spring

7 — Dempfer
8 — the Top casing
9 — the Bottom saddle of a spring
10 — the Flexible hose
11 — Electroconducting of the gauge of speed ABS
12 — the Screw spring
13 — the Shock-absorber


 PERFORMANCE ORDER

  1. Remove a forward wheel.
  2. Turn out a bolt and remove with brackets the shock-absorber holders of a flexible brake hose and electroconducting of the gauge of speed ABS.
  3. Disconnect from the shock-absorber a stabilizer rack.
  4. Give two bottom nuts of fastening of a rack, but yet do not remove bolts.
  5. At removal of the left rack remove the tank of a brake liquid and separate a socket of the gauge of level of a brake liquid.
  6. Give three top nuts of fastening of a rack, and then definitively give two bottom nuts and take out bolts.
  7. Remove assemblage of a rack of a forward suspension bracket.
  8. Establish two bolts with nuts in the bottom arm of fastening of a rack and clamp it in a vice.
  1. By means of the special adaptation compress a spring and, keeping the top saddle of a spring, give a nut.
  1. Remove the top support of a rack, the bearing, the top saddle of a spring and the top cover.
  2. Pressing and extending a shock-absorber rod make sure of smoothness of its course and absence of unusual sounds. At unsatisfactory results of check replace the shock-absorber.

Assemblage and installation

 PERFORMANCE ORDER

  1. Establish on the shock-absorber the bottom saddle of a spring and damper.
  2. By means of the special adaptation compress a screw spring and establish it on the shock-absorber.

The bottom coil of a spring should rest against a groove of the bottom saddle.


  1. Establish the top cover and the top saddle of a spring so that the label not it has been turned outside of the car.
  1. Establish the bearing and the top support of a rack so that the label not it has been turned outside of the car.
  2. Tighten a nut of fastening of a spring and remove from a spring the special adaptation.
  3. Installation is made upside-down. In summary check up corners of installation of forward wheels.