LEXUS RX 300

1998-2003 of release

Repair and car operation


Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
+ Brake system
- Suspension bracket and steering
   The general information
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   - Suspension bracket geometry
      Corners of installation of wheels of the car - the general information
      Check and adjustment of corners of installation of forward wheels
      Check and adjustments of corners of installation of back wheels
+ Body
+ Onboard electric equipment
+ Basic schemes of electric connections

поисковое продвижение интернет магазина

Check and adjustments of corners of installation of back wheels

Check

 PERFORMANCE ORDER

  1. Measure suspension bracket height (the Section Check and adjustment of corners of installation of forward wheels see).
  2. Establish the car on the measuring stand and check up disorder and convergence of back wheels.
  3. If disorder size there do not correspond to requirements of Specifications of the Head the Suspension bracket and a steering, check up suspension bracket components on presence of damages and deterioration.

Disorder of back wheels is not regulated.

  1. If convergence size there do not correspond to requirements of Specifications of the Head the Suspension bracket and a steering, adjust convergence.

Convergence adjustment

 PERFORMANCE ORDER

  1. Measure distance from a disk of each back wheel to a corner of the clown of adjustment of convergence.
  1. If a difference between the measured distances more than 3.0 mm, loosen the a bolt of the clown also turn the clown on a corner demanded for installation average спецификационного of value of convergence.
  1. After adjustment tighten a bolt with effort of 113 Nanometers.