LEXUS RX 300

1998-2003 of release

Repair and car operation



Lexus RX 300
+ Cars Lexus RX-300
+ Controls and operation receptions
+ Options and car routine maintenance
+ The engine
+ Systems of cooling of the engine, heating, ventilation and air conditioning
+ The power supply system and release of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmissionnaja line
+ Brake system
+ Suspension bracket and steering
- Body
   - The external equipment and кузовные elements
      Removal and installation top spacers an impellent compartment
      Removal and installation of bumpers
      Removal and installation of a cowl, its lock and decorative lattice of a radiator
      Removal, installation, dismantling and assemblage of a forward door and its components
      Removal, installation, dismantling and assemblage of a back door and its components
      Removal, dismantling, assemblage and installation of a door of a back and its components
      Removal and installation of cleaners and обтекателя a windscreen
      Removal and installation moldingов
      Removal and spoiler installation
      Removal and installation of the top hatch
   + The salon equipment
+ Onboard electric equipment
+ Basic schemes of electric connections




Removal and installation of cleaners and обтекателя a windscreen

Installation components обтекателя a windscreen

1 — Consolidation between a cowl and обтекателем
2 — Assemblages of levers and edges of screen wipers
3 — the Right lattice обтекателя
4 — the Left lattice обтекателя

5 — the E/motor and draughts of levers of screen wipers
6 — the Socket of the e/motor of screen wipers
7 — the Panel обтекателя a windscreen


 PERFORMANCE ORDER

  1. Give 3 nuts and remove assemblages of levers and edges of screen wipers.
  2. Paste a protective tape on the bottom part of a windscreen.
  3. Remove consolidation between a cowl and обтекателем.
  4. Remove clips and both lattices обтекателя.
  5. Separate a socket of the e/motor of screen wipers.
  1. Turn out 5 bolts and remove the e/motor with draughts of levers of screen wipers.
  1. Give a nut, put adjusting labels, turn out 3 bolts and remove the e/motor from assemblage of draughts.
  1. Turn out 9 bolts and remove the panel обтекателя.
  2. Disconnect hoses from atomizers of washers and remove atomizers.
  3. Installation is made upside-down. Tighten fixture with demanded efforts.
  4. In conclusion of installation tighten nuts of fastening of levers of screen wipers by hand and include screen wipers on one cycle. Adjust positions of levers (the Section condition Check, adjustment and replacement of brushes of screen wipers see) and tighten nuts with demanded efforts.
  5. After installation check up, that the top points of hit of streams of a washing liquid on glass were in the areas designated on an illustration, and the bottom points – in a scope of screen wipers.

Check of atomizers of washers

A — 280 mm
B — 150 mm
C — 10 mm
D — 60 mm